Ledger Hardware Wallet: 1.7 BTC Inaccessible After Device Transition and Address Type Mismatch
IndeterminateNo documentation described the custody setup — whether anyone recovered access is not known.
In December 2023, a BitcoinTalk user reported approximately 1.7 BTC held on a Ledger hardware wallet became inaccessible following a device upgrade. The Bitcoin had been secured since at least 2019 at a Legacy address (19NduweV3Hn8RXHFBQ32pKwCtbP5RBKwQw) and represented the user's primary savings. The user purchased a new Ledger device citing screen dimming issues on the original hardware and attempted to set it up on a newly installed PC.
Upon installing Ledger Live on the new machine, the Bitcoin account did not appear, though it remained visible in Ledger Live on the original PC. When attempting to spend from the old PC, an error message was returned—details were not fully disclosed. Testing with alternative software wallets (Electrum and Sparrow) returned no results except for a small dust amount also visible in Ledger Live. The user had configured a 25th-word passphrase and documented it, though remained uncertain whether Bitcoin had been sent to that derived account or if misconfiguration during new device setup had caused the inaccessibility.
Community diagnosis from experienced users identified the most probable cause: an address type mismatch. Ledger Live's default configuration on new installations may have switched from P2PKH (Legacy, addresses starting with '1') to P2WPKH (Native SegWit, addresses starting with 'bc1'), rendering the funds invisible despite remaining on the blockchain. A secondary possibility was outdated firmware on the original device preventing spend transactions. The community recommended configuring the new Ledger to display Legacy address types, verifying address type selection in Electrum or Sparrow, or importing the seed phrase into Electrum with explicit Legacy address derivation.
No final resolution was documented; the case status remained unknown at the time of reporting.
| Stress condition | Documentation absent |
| Custody system | Hardware wallet with passphrase |
| Outcome | Indeterminate |
| Documentation | Partial |
| Year observed | 2023 |
What the absence of documentation actually removes
What documentation provides is a starting point. Without it, heirs face three unknowns before they face any access problem: does the Bitcoin exist, where is it held, and what is needed to access it. Most of this information cannot be reconstructed after the owner dies or becomes incapacitated. Educated guesses, blockchain searches, and device inventories occasionally locate wallets — but without credentials, finding the wallet does not help.
Cases in this archive where documentation was absent but recovery succeeded typically involved one of two factors: an exchange account where the heir knew the email address and could navigate the account recovery process, or a designated person who had been given credentials informally and could act. Self-custody without any documentation or designated knowledge-holder is consistently the worst combination.
The content of documentation matters as much as its existence. A note that says "my Bitcoin is in a hardware wallet in the safe" is better than nothing but insufficient. Effective documentation specifies: what type of wallet, where the seed phrase is stored, whether a passphrase exists and where it is documented, and any exchange accounts and the email addresses used. It should be tested — the executor should be able to confirm the information is accurate before it is needed.
Documentation does not need to expose credentials to be useful. A document that describes the custody structure, points to where credentials are stored, and names a person who has been briefed can be stored without security risk. The goal is not to put the seed phrase in a filing cabinet — it is to ensure the executor has a map, not a blank wall.
Translate